MacBlog

測試平台 Fedora 7

iscsi target

一開始抓 release 版的 iscsitarget-0.4.15.tar.gz
不過編不起來
後來改抓 svn 版本
$ svn co svn://svn.berlios.de/iscsitarget/trunk

make;make install 編譯安裝都正常

編輯設定檔:
$ vi /etc/ietd.conf
Target iqn.2007-09.candyz:storage.test
Lun 0 Path=/dev/sdb4
Alias iSCSI

$ vi /etc/initiators.allow
iqn.2007-09.candyz:storage.test 192.168.1.0/24

$ vi /etc/initiators.deny
ALL ALL

$ /etc/init.d/iscsi-target start

iscsi initiator

$ yum install iscsi-initiator-utils

$ iscsiadm -m discovery -t sendtargets -p 192.168.1.23:3260

$ /etc/init.d/iscsi start

同時跑 iscsi-target 跟 iscsi 的機器，iscsi-target 要在 iscsi 之前先跑

$ dmesg
Loading iSCSI transport class v2.0-724.
iscsi: registered transport (tcp)
iscsi: registered transport (iser)
scsi4 : iSCSI Initiator over TCP/IP
scsi 4:0:0:0: Direct-Access IET VIRTUAL-DISK 0 PQ: 0 ANSI: 4
sd 4:0:0:0: [sdc] 32515560 512-byte hardware sectors (16648 MB)
sd 4:0:0:0: [sdc] Write Protect is off
sd 4:0:0:0: [sdc] Mode Sense: 77 00 00 08
sd 4:0:0:0: [sdc] Write cache: disabled, read cache: enabled, doesn’t support DPO or FUA

接下來就可以 fdisk mkfs mount umount 等來使用了